Before this change, bisync used some global variables, which could cause errors
if running multiple concurrent bisync runs through the rc. (Running normally
from the command line was not affected.)
This change deglobalizes those variables so that multiple bisync runs can be
safely run at once, from the same rclone instance.
All user visible Durations should be fs.Duration rather than time.Duration. Suffix is then optional and defaults to s. Additional suffices d, w, M and y are supported, in addition to ms, s, m and h - which are the only ones supported by time.Duration. Absolute times can also be specified, and will be interpreted as duration relative to now.
Before this change, the decoder looked only for `io.EOF`, and if any other error
was returned, it could cause an infinite loop. This change fixes the issue by
breaking for any non-nil error.
Background: Bisync uses lock files as a safety feature to prevent
interference from other bisync runs while it is running. Bisync normally
removes these lock files at the end of a run, but if bisync is abruptly
interrupted, these files will be left behind. By default, they will lock out
all future runs, until the user has a chance to manually check things out and
remove the lock.
Before this change, lock files blocked future runs indefinitely, so a single
interrupted run would lock out all future runs forever (absent user
intervention), and there was no way to change this behavior.
After this change, a new --max-lock flag can be used to make lock files
automatically expire after a certain period of time, so that future runs are
not locked out forever, and auto-recovery is possible. --max-lock can be any
duration 2m or greater (or 0 to disable). If set, lock files older than this
will be considered "expired", and future runs will be allowed to disregard them
and proceed. (Note that the --max-lock duration must be set by the process that
left the lock file -- not the later one interpreting it.)
If set, bisync will also "renew" these lock files every
--max-lock_minus_one_minute throughout a run, for extra safety. (For example,
with --max-lock 5m, bisync would renew the lock file (for another 5 minutes)
every 4 minutes until the run has completed.) In other words, it should not be
possible for a lock file to pass its expiration time while the process that
created it is still running -- and you can therefore be reasonably sure that
any _expired_ lock file you may find was left there by an interrupted run, not
one that is still running and just taking awhile.
If --max-lock is 0 or not set, the default is that lock files will never
expire, and will block future runs (of these same two bisync paths)
indefinitely.
For maximum resilience from disruptions, consider setting a relatively short
duration like --max-lock 2m along with --resilient and --recover, and a
relatively frequent cron schedule. The result will be a very robust
"set-it-and-forget-it" bisync run that can automatically bounce back from
almost any interruption it might encounter, without requiring the user to get
involved and run a --resync.
